XYMERTOL BELL METAL

RAPID CURE, MODIFIED POLYUREA PIGMENTED
COATING.

XYMERTOL BELL METAL is a rapid curing, two pack modified polyurea coating that is available in a range of colours. It has a long pot life but quickly cures to a hard, but slightly flexible surface that is extremely abrasion resistant.

Its long pot life and quick cure allows two coats to be applied to small areas from a single mix. This attribute saves time and material.

It is ideal for use on floors, ships decks and in other high wear situations where rapid return to service is required.

Floors can be prepared, several coats of XYMERTOL BELL METAL applied and the premises returned to service within six hours. SUBSTRATES must be prepared and primed correctly. Steel and other ferrous metals should be primed with ARMOURGUARD ST while concrete, timber and most other substrates can be primed with XYMERTOL RAPID PRIMER.

XYMERTOL BELL METAL can be applied by brush, roller or by airless spray.

Type: Two pack, solvent free modified polyurea coating

Cure System: Part moisture cure

Mix Ratio: See label on tin

Hardener: HDI pre-polymer blend, contains less than 0.1% free monomer

Resin Density: 1.4

Coverage: 5-7 m2/litre, depending on surface texture and porosity 

Minimum over-coating time: 30 – 45 minutes 

Solvent: Synsol PU

Colours: Most RAL colours available, depending on quantity required. 

Pack Sizes: 5 , 10 and 25 kilos

Pot Life: up to two hours

Shelf life and Storage: 6-12 months in original, unopened container. Store in cool and dry conditions 

Preparation:  Concrete substrates should preferably be diamond
ground or blasted but if this is not possible the surface must be clean and free of loose material, laitance, oil, grease etc.

Mixing: Add all of the hardener to the tin of resin and mix slowly for several minutes preferably using a flat mixing blade in a drill. Try not to mix air in with the resin as this will reduce pot life. If you require a smaller quantity or
are unable to use all of the material within its pot life, weigh out resin and hardener in the proportions specified on the label using digital scales.

Application: Can be applied by brush, roller or airless spray. A thin coat should be applied ensuring that the material is worked well into pin holes and imperfections so that 100% of the surface has been covered. Avoid leaving excess material to form thick areas as foaming may occur. On some porous substrates a second coat may be required to completely seal all porosity.

Over-coating: XYMERTOL RAPID COLD CURE PRIMER can be overcoated with virtually all other types of coating as soon as it can be walked on which is 20-30 minutes in most conditions. 

Advantages

  • Long pot life, up to two hours in ambient conditions
  • Rapid cure, 30 – 40 minutes at 15c
  • Excellent UV and weathering resistance. Does not yellow
  • Extremely wear resistant and does not scratch easily 
  • Odourless 
  • 100% solids, solvent free 
  •