CONSEAL CERAMIC
Conseal Ceramic is a two part, totally solvent free, ceramic filled epoxy floor coating. It has exceptional wear and abrasion resistance and is suitable for use in high wear areas and in situations where the use of solvent containing paints may be a problem. It has excellent opacity and covering power, is resistant to oil, petrol, diesel fuel, most chemicals and has good resistance to sunlight.
Conseal Ceramic is very easy to mix and apply and little skill is required to produce a good job, provided the mixing and application instructions are followed. For best results we recommend applying two coats. For wet areas or where maximum slip resistance is required, we have a selection of non-slip additives that can be added to the coating to produce a variety of textures.
Typical Uses: As a long lasting, hard wearing floor paint for industrial and domestic application.

Type: Solvent free ceramic filled epoxy coating
Mix Ratio: See label on tin
Hardener: Xyanco 220
Resin Density: 1.5kg/litre
Coverage: 6 sqm per litre, dependent on required thickness
Finish: Semi-gloss
Minimum over-coating time: 12 hours
Maximum over-coating time: 3 Days
Solvent: None required. Xysol safe for cleaning
Colours: A selection of RAL colours.
Pack Sizes: 1, 3, 6, 12 and 18 kilos
Shelf life and Storage: 6-12 months in original, unopened container. Store in cool and dry conditions
Preperation: Concrete substrates should preferably be diamond
ground or blasted but if this is not possible the surface must be clean and free of loose material, laitance, oil, grease etc. Epoxy coatings should not be applied in temperatures of less than 7°C or to substrates less than 7°C. Conseal Ceramic should be stored at 15-25°C for at least 8 hours before use.
Mixing: Conseal Ceramic resin should be pre-mixed in the tin before the hardener is added. Add all of the hardener to the tin of resin and mix thoroughly with an electric mixer. Transfer all of the contents into a clean bucket and mix for another 2-3 minutes. When mixed, the resin and hardener will start to react, generating heat which will accelerate the reaction. The greater the mass of epoxy, the more heat will be generated and the shorter the pot life. To prolong pot life pour the resin into shallow trays or onto the floor. If you require a smaller quantity, or are unable to use all of the material within its pot life, weigh out resin and hardener in the proportions specified on the label using digital kitchen scales. Please see our website for more information on the proper mixing of epoxy resins.
Application: Should be applied by brush and/or medium pile roller. For best results we recommend applying two coats.
Over-coating: Can be over-coated as soon as it is touch dry as shown in the table overleaf according to the ambient temperature. If it is allowed to cure beyond the maximum over-coating time, glossy areas must be abraded before any further coatings are applied.
Advantages
- Long lasting, ceramic content makes CONSEAL CERAMIC hard wearing and
eliminates frequent recoating - Economical, saves time and money.
- Virtually odour free
- Excellent adhesion to properly prepared substrates.
- Easy to apply, lower viscosity than other solvent free epoxy coatings
- Provides an attractive finish
- Anti static and acid resistant grades are also available.