Carbonamineᵀᴹ Rapid Cold Cure Self Leveller
Self Smoothing, Modified Polyurea System for Perfect Floors
Carbonamine Rapid Cold Cure Self Leveller is a specially formulated, two part epoxy system that when mixed with its aggregate pack will provide a low viscosity compound which is easy to apply with simple equipment.
It will provide a perfect, seamless floor that is completely free from air bubbles and other defects and will cure in temperatures as low as 0°c, thanks to Cold Cure Technology.
It contains a unique blend of additives that rapidly and completely remove all entrained air that often spoil the surface of similar systems. Large areas can be quickly finished to produce an attractive, durable floor that is easy to clean. Carbonamine Rapid Cold Cure Self Leveller is available pigmented in a range of standard colours. Custom colours can be produced in quantities over 200kgs.

Type: Three pack, solvent free modified polyurea coating
Mix Ratio: See label on tin
Hardener: HDI Pre-polymer blend, contains less than 0.1% free monomer
Resin Density: 1.71
Coverage: 5-6 m2/litre, per 25Kg pack at 2.55mm thick
Minimum over-coating time: 40 minutes
Maximum over-coating time: 48 hours
Solvent: Synsol Safe for cleaning
Colours: Most RAL colours available, depending on quantity required.
Pack Sizes: 5, 10 and 25 kilos
Samples: Available on request
Priming: It is essential to prime the prepared surface with Xymertol Rapid Prime. Its purpose is to seal any porosity in the concrete and thus prevent escaping air rising through the Xymertol Rapid Cold Cure Self Leveller as it sets and thus spoiling its surface. When the primer has cured inspect it to ensure that all porosity has been sealed. Poor quality concrete will often require a second coat of primer worked into the surface as it is applied.
Mixing: Can be mixed in a bucket with a plaster mixer or with powered mixers. Pour all of the hardener into the tub of resin and mix for several minutes. Pour the mixed resin into a larger container and mix again to ensure that the resin and hardener have been thoroughly mixed. Failure to to mix the components as instructed may cause the material not to cure properly. Continue mixing and slowly add the aggregate. Continue mixing until a smooth, homogenous texture is achieved.
Application: Can be applied by brush, roller or airless spray. A thin coat should be applied ensuring that the material is worked well into pin holes and imperfections so that 100% of the surface has been covered. Avoid leaving excess material to form thick areas as foaming may occur. On some porous substrates a second coat may be required to completely seal all porosity
Advantages
- Provides a smooth, defect free seamless floor
- Will cure in temperatures as low as 0°c
- Waterproof and easy to clean
- Excellent for new or for restoring old, damaged concrete floors
- Easy to lay
- Durable, tough and hard wearing
- Choice of non slip finishes available for wet areas
- Available in standard and custom colours
- Hygienic option available to kill MRSA E-Coli etc.